![]() I had no idea that the M圜loud family had such a varying set of firmwares across until I received the unit, and had (apparently errantly) assumed the Goodsync folks would have specified if only certain versions were supported. In this case use the following command to start GsServer manually:Ĭpt_paranoia, The goodsync page was all I went off of. Installer may fail to update-rc.d if you are running Busybox-based firmware. I note the Goodsync page you linked isn’t explicit about which of the many variants of the M圜loud family of devices it is intended for (WDCloud, M圜loud, Mirror, DL, EX2, EX4, Pro) As I understand it, Goodsync is paid for software, so if you’ve paid for it, go and get support for their product. If it was Goodsync, then I’d suggest asking them. The lower-end devices don’t officially support the installation of ‘apps’. Since WD don’t officially support the use of SSH to install packages on the M圜loud (of any variant, I don’t think), it seems unlikely they’d be advocating/promoting the installation of software that must be installed via SSH. Listed as compatible by whom…? WD? Goodsync? Purchased the 4100 as it was listed as compatible with goodsync, and now we’ve wasted over 6 hours and can’t get goodsync to run GoodSync checks for new changes approximately every 3 seconds, this time quant is configurable.On File Change initiates Analyze and Sync, which results in locking of sync folder by GS lock files. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |